-----------------

poster: Flamekrayt
subject: HP2 bar
date: Thu Jul 13 17:34:56 2006

hmm, looked through the archives, and found only one post which was posted by zif on how to make an event for the hp, sp bars.



but i am either blind or tired or something.. but i can't get the EP bar coz there is no @EP and no @MAXEP.



any help plz? thanks.

-----------------

poster: Zifnab
subject: >HP2 bar
date: Thu Jul 13 18:49:28 2006

On Thu Jul 13 17:34:56 2006 Flamekrayt wrote post #1:
> hmm, looked through the archives, and found only one post which was posted
by zif on how to make an event for the hp, sp bars.
> 
> but i am either blind or tired or something.. but i can't get the EP bar
coz there is no @EP and no @MAXEP.
> 
> any help plz? thanks.

I do not have portal installed here at work but there are a set of variables
that correspond to the hp bars. Look in the help for them.

-----------------

poster: Flamekrayt
subject: >>HP2 bar
date: Fri Jul 14 13:45:33 2006

On Thu Jul 13 18:49:28 2006 Zifnab wrote post #2 in client.portal:

> On Thu Jul 13 17:34:56 2006 Flamekrayt wrote post #1:

> > hmm, looked through the archives, and found only one post which was posted

> by zif on how to make an event for the hp, sp bars.

> > 

> > but i am either blind or tired or something.. but i can't get the EP bar

> coz there is no @EP and no @MAXEP.

> > 

> > any help plz? thanks.

> 

> I do not have portal installed here at work but there are a set of variables

> that correspond to the hp bars. Look in the help for them.

> 





not sure if its just my bad luck or anything.. i tried using the HP bar setup assistant.. but i think it backfired.. after i did that, it gave me this error: 'Key Violation'.



because of that, i could not close the program. (the normal way, which is to go to file > exit program. could not close it with the 'X' on top either.



had to do the ctrl+alt+del, then end program.



i tried opening Portal again, the program loaded, but i could not load my profile. so i had to manually export my profile, change its values, (deleting the event that the HP bar assistant created), before i could launch my profile.



>>For The Record<<



after i deleted that event the HP bar created, when i logged into portal, the HP2 bar and HP3 bar worked automatically.. i have no idea how.. it just did..



-------------------------------------------------------------------------------



Thank you Zif, priesty and Fjunix for trying to help ^^